Origami And Folded Paper | Origami And Folded Paper Guide

Birds are one of the oldest known and used in the ancient Japanese art of paper folding. In fact, the oldest known book Origami "Orika Senbazuru" contains instructions on how to create groups of 1,000 paper cranes. Artists make origami birds, including chickens. After this step, only rarely, you can do some sort of chicken with a surprise at the end of origami.

Things you need use

* Origami Paper, Scissors



Instructions

* 1

Place a piece of origami paper on a flat surface and the color of the hand in the corner in front of him.
* 2

Lean forward until you reach the top.
* 3

Fold half of the triangle from left to right. Now you should have a triangular front and rear wings.
* 4

Remove the cover by reducing the crease from the bottom up, and to form a diamond.
* 5

Switching model.
* 6

Repeat step 4 to create for the other flap to a second diamond.
* 7

Fold the top of the front and back at the bottom of the diamond. Now the model is similar to a boat with sails.
* 8

Fold the left flap from prosecution.
* 9

Take the model and repeat step 8 on the opposite side. Now you should have a double layer of white diamonds.
* 10

Turn right at the upper left corner and time to meet with a diamond. Turner and the other side of the same model.
* 11

Fold the top and then do the same on the ground floor. If a new form, the two points that has pushed the base.
* 12

The second point on the bottom-up model. It should form a triangle.
* 13

Take the model, and repeat Step 12
* 14

Make a left edge of each triangle, the extent to which cuts the upper left corner. Form of chicken wings.
* 15

See the model of the upper left and thin. Fold well.
* 16

Cancel crumpled up and open the message. Press the center rise up to the point where it inside along the fold line, which was created in the previous step. This is a reverse double whammy.
* 17

Bend the tip of no return, the final step was created in a corner, then touched the edge of the model. Fold well.
* 18

Remove the cover and flip the pages. This creates a chicken tail feathers.
* 19

Fold the left edge of the corner of the model, and give up high and folds on the sides.
* 20

Bend the tip of no return, which was created in the previous stage in the corner.
* 21

Remove the lid and press the lid section is repealed and the fold lines that are created in the previous step. It folded in the back seat.
* 22

Take the tip of the point in recent times and the back bent upward at an angle.
* 23

Undo and fold. This chicken's head and beak.
* 24

Cut the deepest point of the model. Save this item for the next step.